TedStixon

6th Jun 2018

Jigsaw (2017)

Corrected entry: The scars on the back of Logan are inclined, but the saws in the beginning were arranged horizontally. (00:47:00)

hoppbro

Correction: Logan is seen struggling and wriggling about, which is totally understandable. Hence, the cuts on his back aren't perfectly straight, and are at different angles - he was moving the entire time.

TedStixon

15th May 2018

Jigsaw (2017)

Corrected entry: During the final scene with the laser collar traps, we can see that there are seven lasers attached to the collar (as per the bottom-up view of the beams burning through the ceiling above Halloran.) However, when the trap goes off, it makes eight cuts (as per the top-down view of Halloran's former head).

Logic Johnson

Correction: The cuts all line up perfectly, so one could assume that the "extra slice" on the back of his head is from the laser in the front, as the slices on the front and back line up. It just depends on how strong the laser-cutters are. As indicated earlier in the film, they are strong enough to slice through metal quickly and with ease, so it could be assumed that they would go through flesh and bone like butter. (You also gotta remember, the bone in the skull is actually pretty thin for the most part).

TedStixon

26th Feb 2018

Jigsaw (2017)

Revealing mistake: At the beginning when the coroner cuts the bucket off the body, the metal is red hot and her pinky touches it. Not only does it not burn the glove but it doesn't burn her.

brianjr0412

Upvote valid corrections to help move entries into the corrections section.

Suggested correction: The metal is not red hot, it was cut by a laser that gives off a small amount of smoke. Nothing says the metal is hot. So no burn is reasonable.

Ssiscool

Your correction suggestion completely contradicts how laser-cutters work. The metal would definitely be hot if cut with a laser cutter. That's how laser cutters work - they essentially melt the material they're pointed at in a very controlled fashion, and they do indeed get quite hot.

TedStixon

Smoke doesn't make the metal glow red, that would be heat. Also for the laser to cut through thr metal it needs to heat it up.

brianjr0412

Join the mailing list

Separate from membership, this is to get updates about mistakes in recent releases. Addresses are not passed on to any third party, and are used solely for direct communication from this site. You can unsubscribe at any time.

Check out the mistake & trivia books, on Kindle and in paperback.